The remote command light on your STB and on your remote control should flash each time you press a remote key. Make sure you point your remote directly towards your STB and nothing is between the two. There are no batteries or the batteries may have become flat. Refer this guide to program your remoteĢ. The remote works with the TV & not with my STB.ġ.
Check all your connection and consult or call us. The cable connections are may be faulty or missingĤ. The connections are right, but the TV is not connected up to external AV sourceĤ. The front panel of the Set-Top box is correctĬable operator, Aerial connection or VCD,ģ. No Picture, No Sound but the indication on Press on the power button on the Remote control to bring the Set-Top box out of standby. Press to ON/OFF button on the front of the STB. Set-Top box is not plugged into the mains or is not switched on.Ĭheck mains connections. Read these troubleshooting tips in case you have a problem using your equipment.ĭo check the following before you call us. This will reboot your dish receiver and will most likely solve the prevalent issue. Keep pressing till you see the light blinking faster. Press the ‘+’ button and the power button at the same time.
Please recharge your Account immediately to resume services & keep the Set Top Box ON for at least 20 minutes after recharge. How do you fix a dish TV when it says no signal To fix this, follow these steps: Turn on the receiver.
#DISH NETWORK NO SIGNAL ON TV 2 UPGRADE#
To upgrade your package please call customer care.Īccount is suspended due to low balance (Error Code: 6) Your current subscription does not include this channelĪdd a top-up or upgrade your package. This channel is not subscribed by you (Error: 4) If issue still persists, please call the call center. Gently pull out the viewing card, wipe it with a dry cloth and reinsert with the gold chip facing down and arrow towards the box. If the viewing card is not inserted properly or not being detected Please check, viewing card is not inserted properly in Set top box (Error Code:4) If unable to view Channel 099 (Default Channel) & 121 (Recharge Info), please call the call center. Restart the Set Top Box by switching power Off and then On.ĥ. Please check and remove any obstruction around the dish.Ĥ. Check Weather condition (Problem would be temporary if there is a windstorm, rain or thunderstorm).Ģ.
#DISH NETWORK NO SIGNAL ON TV 2 MANUAL#
If you are unable to view the signal from the receiver after following the steps in this solution, refer to the operations manual supplied with the Dish Network receiver or contact the Dish Network support office for further assistance.1. Using the remote supplied with the TV, enter the selected output channel number and then press the Enter button.If Cable mode is selected, select a channel between the numbers 73-125 as the output channel on the receiver. If Air Mode is selected, select a channel between the numbers 21-69 as the output channel on the receiver.
0 kommentar(er)
